Midmark M11 Specifications download pdf (Page 37)

6. While holding the paper (1) in place, press the right side (B) of the switch to

the ON / FEED position and hold. The printer will activate and a rubber roller

will put the paper into the printer compartment. Continue to hold the switch

down until the paper emerges from the top of the printer mechanism. Then,

when 2.5 cm (1 in.) of paper has emerged from the top of the printer, release

the switch.

7. Pull the paper (1) through the printer until 5 to 7.5 cm (2 to 3 in.) of paper is

exposed.

8. Put the paper spindle (3) into the paper roll and place the roll with the spindle

onto the grooves (4) at the back of the printer.

9. Turn the paper roll so as to take up the slack in the paper feeding to the

printer. Make sure the roll of paper turns freely. If it does not turn freely, the

paper will jam and possibly damage the printer mechanism.

About the Cartridge Ribbon

The printer takes a cartridge ribbon. When printing becomes faint or difficult to

see, you should replace the cartridge. If the printer is used infrequently, the

print impression sometimes becomes weak because the ribbon dries out. If the

printed material is difficult to read and you suspect this is the cause of the prob-

lem, advance to a properly inked portion of the ribbon by pressing and holding

the switch in the ON / FEED position for 3 seconds.

Return To Table Of Contents

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Midmark M11 Specifications Page 37